FNX940 v1.0

Download this torrent!

FNX940 v1.0

Category: Other
Total size: 0.01 kB
Added: 2025-03-10 23:38:46

Share ratio: 0 seeders, 4 leechers
Info Hash: 7EE6B2766FE9FADD750F56E906ABAB824DCA4926
Last updated: 5.2 hours ago

# FNX940 A frame for FNX-9 and FNX-40 part kits by nguyenkvvn minor geometry referenced from the FNS940 model by TMS ## Description The FNX is a polymer hammer-fired pistol availible in 9mm and .40 S&W. It is a precursor to the FNS series of pistols. It uses plates for rails, rather than a monolithic locking block or integrated into the fire-control housings. It is only availible commercially in full-size configuration. Geometry that was referenced from the FNS940 model by TMS includes but is not limited to: magazine button cut-out, magazine button spring relief, trigger pin location. ## Materials Required You will need a set of each below for each FNX-9/40 you make. This model is compatible with any FNX-9 or FNX-40 parts kit. It is *not* compatible with the FNX-45 or FNX-45 Tactical. - x1 **Parts Kit** - Procure a parts kit of your preferred caliber. - x1 **Magazine** - Procure a magazine of your preferred caliber ## Instructions * Print with PLA+, or Tough PLA. * Tree supports are recommended * Print *rails down* on the bed * It is imperative your printer has no elephant footing- otherwise the rail plates may not seat properly! _Assembly instructions can be found in the rich-text PDF included._ ## Change Log - v1.0: Release * Promotion to release - v0.4: Private Beta Candiate 4 * Revised front takedown lever clearances * Omitted horseshoe geometry * Refined front rail fitment geometry - v0.3: Private Beta Candiate 3 * Loosened tolerances for rear rail plates * Loosened tolerances for front rail / locking block places - v0.2: Private Beta Candiate 2 * Added right-hand safety selector cutout * Re-introduced some takedown-lever geometry * Tightened tolerances for the front locking block plates - v0.1: Private Beta Candidate 1 * Initial commit ## License No license selected